Random notes

Feel free to cut-n-paste from mails and IRC into this page. Grammar and spelling are not so important.

What numbers do FWH/LPC chips tend to start with?

39/49/50 with 49 being the most common. I've seen 39/49 chips which are parallel but that's ususual. 50 is not very common as model number.

Dirty little secrets

14:10 < carldani> there's a dirty little secret for EEPROMs 14:10 < carldani> actually, two secrets 14:11 < carldani> 1. old parallel flash chips often need a special board enable or the flash chip will ignore any commands (get ID, erase, write) 14:11 < carldani> (that's the case with most boards of PIIX4 or older era, flash chip model names are usually *29*) 14:12 < carldani> 2. modern chipsets usually have more than one flash bus, and some boards even have additional bus translation chips 14:13 < carldani> so for modern boards you have to check the LPC/FWH bus of the chipset, then you check the SPI bus of the chipset (if supported by the chipset and supported by flashrom), then you check the SPI bus of any LPC-to-SPI bus translation chip 14:13 < carldani> on the M2N68, we only probe for LPC chips, but the chip on the board is SPI 14:14 < carldani> that means the SPI chip is either attached to the SPI bus of the chipset (and we don't have a driver for that due to lack of docs) 14:14 < carldani> or it is behind some LPC/SPI translation chip (some of which we support) 14:14 < carldani> the translation test is performed with -p it87spi 14:15 < carldani> as you can see, it's complicated 14:15 < carldani> very very complicated 14:15 < carldani> worst of all, autodetection is basically impossible