User:GNUtoo

I've no code in flashrom yet, but I made a flashrom compatible arduino programmer and participated in testing and documentation.

My hardware

Device or programmer	Flash chip	Test result
Asus M4A785T-M mainboard	W25x80 (DIP8)	Yes with the BIOS Yes with coreboot
Asrock E350M1	A25L032	Yes from coreboot Untested from the BIOS
~~Lenovo X60~~	~~MX25L1605D/MX25L1608D~~	~~Yes with coreboot.~~
Lenovo X60	SST25VF016B	Yes with coreboot.
Lenovo X60T	MX25L1605D/MX25L1608D	Yes with coreboot
Lenovo T60	MX25L1605D/MX25L1608D	Yes with coreboot
PCEngines Alix.1c		Yes with coreboot Yes with the recovery LPC dongle
Asus N71JQ		Requires some bit flippings(with ifdtool and an external programmer) in the flash descriptor. Not tested internally.

Device or programmer	Status
Arduino uno (serprog)	Requires a 5v->3.3v level shifter for most current flash chips. Issues with the 8u2/8u3 when using the serial port at high speed.
Arduino duemillanove (serprog)	Requires a 5v->3.3v level shifter for most current flash chips. Works fine otherwise.
Arduino Due ( no support for it yet )	3.3v level output on SPI. Not working: No support for it yet.
openmoko debug board (ft2232_spi:type=openmoko)	Works fine
3com PCI NIC (10b7:9200) (nic3com)	Works fine
Sata SII PCI card	writing and erasing worked fine.
Really old PCI realtek cards	No parallel chip to test
Some GNU/Linux embedded boards (linux_spi)	Backporting some mainline kernel patches is required on some very old (2.6.35) kernel for omap3. Works fine otherwise
~~An atahpt PCI card~~	Didn't work when adding the PCI IDS, but the atahpt is known not to work according to the mailing list.
~~old AGP Nvidia card~~	Worked with a patch (documented below)
Nvidia geforce 210 PCIe 16x card	didn't work when adding the PIC IDs

I've also the following hardware:

Don't try that, it's dangerous!!!!