Flashrom

Flashrom is a utility which can be used to detect, read, or write BIOS chips (DIP, PLCC, SPI).

Supported devices

Note: There are probably some flash ROM chips which are compatible to the ones listed below.

Flash chips Vendor Flash part Status AMD AM-29F040B OK AMD AM-29F016D OK ASD AE49F2008 OK Atmel AT-29C040A OK Atmel AT-29C020 OK Atmel AT-49F002(N) OK6 Atmel AT-49F002(N)T OK6 EMST F49B002UA OK Fujitsu MBM29F400TC OK5 Intel®(Firmware Hub) 82802AB OK Intel®(Firmware Hub) 82802AC OK M-Systems MD-2802 OK1 MX MX-29F002 OK PMC PMC-49FL002 OK PMC PMC-49FL004 OK Sharp LHF-00L04 OK SST SST-29EE020A OK SST SST-28SF040A OK SST SST-39SF010A OK SST SST-39SF020A OK SST SST-39SF040 OK SST SST-39VF020 OK SST SST-49LF040B OK SST SST-49LF040 OK SST SST-49LF020A OK SST SST-49LF080A OK SST SST-49LF002A/B OK SST SST-49LF003A/B OK SST SST-49LF004A/B OK SST SST-49LF008A OK SST SST-49LF004C OK SST SST-49LF008C OK SST SST-49LF016C OK SST SST-49LF160C OK

Flash chips (cont'd) Vendor Flash part Status ST ST-M50FLW040A OK4 ST ST-M50FLW040B OK4 ST ST-M50FLW080A OK4 ST ST-M50FLW080B OK4 ST ST-M50FW040 OK4 ST ST-M50FW080 OK4 ST ST-M50FW016 OK4 ST ST-M50LPW116 OK4 ST ST-M29F002B OK ST ST-M29F002T OK ST ST-M29F002NT OK ST ST-M29F400BT OK ST ST-M29F040B OK ST ST-M29W010B OK4 ST ST-M29W040B OK4 SyncMOS S29C51001T/B OK4 SyncMOS S29C51002T/B OK SyncMOS S29C51004T/B OK4 SyncMOS S29C31004T OK4 Winbond™ W29C011 OK Winbond™ W29C020C OK Winbond™ W29C040P OK Winbond™ W29EE011 OK Winbond™ W49F002U OK Winbond™ W49V002A OK Winbond™ W49V002FA OK Winbond™ W39V040FA OK Winbond™ W39V040A OK Winbond™ W39V040B OK Winbond™ W39V080A OK

Southbridges Vendor Southbridge Status ALi M1533 OK AMD Geode™ CS5530/CS5530A OK AMD Geode™ SC1100 ? AMD AMD-8111 OK ATI SB400 ? Broadcom HT-1000 OK Intel®  ICH OK2 Intel®  PIIX4/PIIX4E/PIIX4M OK Intel®  440MX OK NVIDIA CK804 OK NVIDIA MCP51 ? NVIDIA MCP55 OK SiS 630 ? SiS 5595 ? VIA CX700 OK VIA VT8231 ? VIA VT8235 ? VIA VT8237 ? VIA VT82C686 ?

¹ Unsupported, disabled by default.
² This includes the ICH, ICH0, ICH2, ICH2-M, ICH3-S, ICH3-M, ICH4/ICH4-L, ICH4-M, ICH5/ICH5R, ICH6/ICH6R, ICH6-M, ICH7DH, ICH7/ICH7R, ICH7M, ICH7MDH, ICH8/ICH8R, ICH8DH, and ICH8DO chipsets. ICH2: Identifying and reading chips seems to work, but there are reports that writing may not work on some mainboards.
⁴ Untested, but should work.
⁵ Only reading the chip, but not writing to it has been tested. Both is expected to work, though.
⁶ Should work, but only reading (not writing or erasing) the chip has been tested.

Supported mainboards

This is a list of mainboards where we have verified that they either do or do not need any special initialization to make flashrom work (given flashrom supports the respective southbridge and ROM chip), or that they do not yet work at all. If they do not work, support may or may not be added later.

Mainboards which don't appear in the list may or may not work (we don't know, someone has to give it a try). Please report any further verified mainboards on the mailinglist or add them here directly.

Known-good Vendor Mainboard Status Advantech PCM-5820 OK ASI MB-5BLMP1 OK ASUS A8N-E OK ASUS A8NE-FM/S OK ASUS A8N-SLI Premium OK ASUS M2A-VM OK5 ASUS P2B OK ASUS P2B-F OK BCOM WinNET1006 OK GIGABYTE GA-6BXC OK Tyan S1846 OK Tyan S2881 OK Tyan S2882 OK

Known-good (but special setup required) Vendor Mainboard Required option Status Acorp 6A815EPD -m acorp:6a815epd OK agámi Aruma/AIS6000 -m AGAMI:ARUMA OK ASUS A7V400-MX — OK ASUS A7V8X-MX — OK ASUS A8V-E SE — OK7 ASUS P5A -m asus:p5a OK EPoX EP-BX3 -m epox:ep-bx3 OK IBM x3455 -m ibm:x3455 OK GIGABYTE GA-M57SLI-S4 -m gigabyte:m57sli SEMI-SUPPORTED3 GIGABYTE GA-M61P-S3 -m gigabyte:m61p OK IWILL DK8-HTX -m iwill:dk8_htx OK MSI K8N Neo3 -m msi:k8n-neo3 OK Tyan S2498 (Tomcat K7M) — OK VIA EPIA-M — OK2 VIA EPIA-MII — OK2

Known-bad Vendor Mainboard Status ASUS MEW-AM No ASUS MEW-VM No Biostar M6TBA No MSI MS-7260 (K9N Neo) SEMI-SUPPORTED4

¹ Used in the IGEL WinNET III thin client.
² Might also work for other CLE266 based EPIAs.
³ Flashrom works great when booted with the proprietary BIOS. Once booted in coreboot, it does not work reliably. See bug #87.
⁴ Interestingly flashrom does not work when the vendor BIOS is booted, but it does work flawlessly when the machine is booted with coreboot.
⁵ See http://www.coreboot.org/pipermail/coreboot/2007-September/025281.html.
⁶ Used in the IGEL-316 thin client.
⁷ See http://www.coreboot.org/pipermail/coreboot/2007-October/026496.html.

Installation

Requirements

Flashrom requires the pciutils and zlib and the respective development packages in order to be built.

In Debian unstable these development packages are called pciutils-dev and zlib1g-dev. Most other distributions call them pciutils-devel and zlib-devel.

Manual Installation

$ svn co svn://coreboot.org/repos/trunk/util/flashrom
$ cd flashrom
$ make
$ sudo make install

Debian

$ sudo aptitude install flashrom

Fedora

$ sudo yum install flashrom

Mandriva

$ urpmi flashrom

Usage

Detect whether flashrom knows about your chipset/mainboard/BIOS chip:

$ flashrom

Read the current BIOS image into a file:

$ flashrom -r backup.bin

Write a BIOS image (proprietary or coreboot) on the ROM chip:

$ flashrom -wv newbios.bin

WARNING: This will overwrite your current BIOS! Make sure you know what you're doing!

For more documentation please see the flashrom README or the manpage.