MSI JSPI1
This wiki is retired
Our website is https://www.flashrom.org, instructions on how to add or update documentation are here
All wiki content available in read-only mode at wiki.flashrom.org
JSPI1 is a 5x2 or 6x2 2.0mm pitch pin header on many MSI motherboards. It is used to recover from bad boot ROM images. Specifically, it appears to be used to connect an alternate ROM with a working image. Pull the #HOLD line low to deselect the onboard SPI ROM, allowing another SPI ROM to take its place on the bus. Pull the #WP line high to disable write-protection. Some boards use 1.8V flash chips, while others use 3.3V flash chips; Check the flash chip datasheet to determine the correct value.
| name | pin | pin | name |
|---|---|---|---|
| VCC | 1 | 2 | VCC |
| MISO | 3 | 4 | MOSI |
| #SS | 5 | 6 | SCLK |
| GND | 7 | 8 | GND |
| #HOLD | 9 | 10 | NC |
| name | pin | pin | name |
|---|---|---|---|
| VCC | 1 | 2 | VCC |
| SO | 3 | 4 | SI |
| #SS | 5 | 6 | CLK |
| GND | 7 | 8 | GND |
| NC | 9 | 10 | NC (no pin) |
| #WP | 11 | 12 | #HOLD |
| name | function |
|---|---|
| VCC | Voltage (See flash chip datasheet) |
| MISO | SPI Master In/Slave Out |
| MOSI | SPI Master Out/Slave In |
| #SS | SPI Slave (Chip) Select (active low) |
| SCLK | SPI Clock |
| GND | ground/common |
| #HOLD | SPI hold (active low) |
| #WP | SPI write-protect (active low) |
| NC | Not Connected (or no pin) |