Flashrom

Flashrom is a utility written for LinuxBIOS and maintained in the LinuxBIOS Subversion repository. It can be used to detect BIOS chips (DIP, PLCC), read their contents and write new contents on the chips ("flashing").

Supported devices

Note: The LinuxBIOSv1 version of Flashrom ("flash_and_burn") only supported a very small number of devices. Always use the latest Flashrom version from LinuxBIOSv2! There are some compatible chips out to the below list.

Flash chips Vendor Flash part Status AMD AM-29F040B OK AMD AM-29F016D OK ASD AE49F2008 OK Atmel AT-29C040A OK Atmel AT-29C020 OK EMST F49B002UA OK Intel®(Firmware Hub) 82802AB OK Intel®(Firmware Hub) 82802AC OK M-Systems MD-2802 OK1 MX MX-29F002 OK PMC PMC-49FL002 OK PMC PMC-49FL004 OK Sharp LHF-00L04 OK SST SST-29EE020A OK SST SST-28SF040A OK SST SST-39SF010A OK SST SST-39SF020A OK SST SST-39SF040 OK SST SST-39VF020 OK SST SST-49LF040B OK SST SST-49LF040 OK SST SST-49LF020A OK SST SST-49LF080A OK SST SST-49LF002A/B OK SST SST-49LF003A/B OK SST SST-49LF004A/B OK SST SST-49LF008A OK SST SST-49LF004C OK SST SST-49LF008C OK SST SST-49LF016C OK SST SST-49LF160C OK ST ST-M29F002B OK ST ST-M29F002T OK ST ST-M29F002NT OK ST ST-M29F400BT OK ST ST-M29F040B OK SyncMOS S29C51001T/B OK4 SyncMOS S29C51002T/B OK SyncMOS S29C51004T/B OK4 SyncMOS S29C31004T OK4 Winbond™ W29C011 OK Winbond™ W29C020C OK Winbond™ W49F002U OK Winbond™ W49V002A OK Winbond™ W49V002FA OK Winbond™ W39V040A OK Winbond™ W39V040B OK Winbond™ W39V080A OK

Southbridges Vendor Southbridge Status ALi M1533 OK AMD CS5530 ? AMD Geode™ SC1100 ? AMD AMD-8111 OK ATI SB400 ? Intel®  ICH2 OK3 Intel®  PIIX4/PIIX4E/PIIX4M OK NVIDIA CK804 OK NVIDIA MCP51 ? NVIDIA MCP55 OK SiS 630 ? SiS 5595 ? VIA CX700 OK VIA VT8231 ? VIA VT8235 ? VIA VT8237 ? VIA VT82C686 ?

Mainboards which need special setup Vendor Mainboard Required option Status agámi Aruma/AIS6000 -m AGAMI:ARUMA OK ASUS A7V400-MX — OK ASUS A7V8X-MX — OK ASUS P5A -m asus:p5a OK IWILL DK8-HTX -m iwill:dk8_htx OK VIA EPIA-M — OK5 VIA EPIA-MII — OK5

¹ Unsupported, disabled by default.
² This includes the ICH, ICH0, ICH2, ICH2-M, ICH3-S, ICH3-M, ICH4/ICH4-L, ICH4-M, ICH5/ICH5R, ICH6/ICH6R, ICH6-M, ICH7DH, ICH7/ICH7R, ICH7M, ICH7MDH, ICH8/ICH8R, ICH8DH, and ICH8DO chipsets.
³ Identifying and reading chips seems to work, but there are reports that writing may not work on some mainboards.
⁴ Untested, but should work.
⁵ Might also work for other CLE266 based EPIAs.

Installation

Requirements

Flashrom requires the libpci and zlib development packages in order to be built.

In Debian unstable the respective packages are called libpci-dev and zlib1g-dev.

Manual Installation

$ svn co svn://linuxbios.org/repos/trunk/LinuxBIOSv2 
$ cd LinuxBIOSv2/util/flashrom
$ make
$ make install

Debian

$ apt-get install flashrom