Serprog/ESP8266 flasher: Difference between revisions
Jump to navigation
Jump to search
(Created page with "This is more than just WIP. hetii has started a serprog implementation on the ESP8266 and Stefanct will set up test hardware if that's ready. Till then this will host various...") |
No edit summary |
||
| Line 1: | Line 1: | ||
This is more than just WIP. hetii has started a serprog implementation on the ESP8266 and Stefanct will set up test hardware if that's ready. | This is more than just WIP. hetii has started a serprog implementation on the ESP8266 and Stefanct will set up test hardware if that's ready. | ||
Till then this will host various ESP-related bits not necessarily related to Serprog. | Till then this will host various ESP-related bits not necessarily related to Serprog. | ||
= UART = | |||
The default UART requires line feeds to be sent. | The default UART requires line feeds to be sent. | ||
| Line 23: | Line 25: | ||
Build:1.3.0.2 Sep 11 2015 11:48:04 | Build:1.3.0.2 Sep 11 2015 11:48:04 | ||
OK | OK | ||
[https://github.com/espressif/ESP8266_AT/wiki/AT_Description Documentation of AT commands] | |||
= WLAN = | |||
To connect to an existing network one needs to | |||
# enable client mode | |||
# enable DHCP | |||
# connect to an AP | |||
AT+CWMODE=1 | |||
AT+CWDHCP=1,1 | |||
AT+CWJAP="ssid","password" | |||
Revision as of 00:06, 16 May 2016
This is more than just WIP. hetii has started a serprog implementation on the ESP8266 and Stefanct will set up test hardware if that's ready. Till then this will host various ESP-related bits not necessarily related to Serprog.
UART
The default UART requires line feeds to be sent. This can be done by ending every line with '<enter> <ctrl>-j'. A more convenient solution is to use automatic mapping provided by a terminal emulator, e.g.:
picocom -b 115200 --omap crcrlf /dev/ttyUSB1
After boot you should see (at least) the ready message as below. You can test if the UART connection works correctly by issuing AT commands.
Ai-Thinker Technology Co.,Ltd. ready AT OK AT+GMR AT version:0.40.0.0(Aug 8 2015 14:45:58) SDK version:1.3.0 Ai-Thinker Technology Co.,Ltd. Build:1.3.0.2 Sep 11 2015 11:48:04 OK
WLAN
To connect to an existing network one needs to
- enable client mode
- enable DHCP
- connect to an AP
AT+CWMODE=1 AT+CWDHCP=1,1 AT+CWJAP="ssid","password"