FT2232SPI Programmer: Difference between revisions
Jump to navigation
Jump to search
(→Setup: Document working setup .) |
m (→Setup) |
||
| Line 19: | Line 19: | ||
== Setup == | == Setup == | ||
* | * You must connect '''pins 8 and 9''', which configures the device to be powered by USB. Without this connection it will not be powered, and thus not be detected by your OS (e.g. it will not appear in the '''lsusb''' output). | ||
* | * You need a 3.3V voltage regulator and two capacitors (e.g. 100nF and 10uF, but slightly different values should also work) to convert the 5V from USB to 3.3V, so you can power the 3.3V SPI BIOS chip. | ||
** TODO: Details | ** TODO: Details | ||
* Connect the following pins from the DLP-USB1232H to the SPI BIOS chip: | * Connect the following pins from the DLP-USB1232H to the SPI BIOS chip: | ||
| Line 28: | Line 28: | ||
** '''5 (CS)''' to '''CS#''' | ** '''5 (CS)''' to '''CS#''' | ||
** The '''WP# and HOLD#''' pins should be tied to '''VCC'''. | ** The '''WP# and HOLD#''' pins should be tied to '''VCC'''. | ||
** All '''GND''' pins should be connected together ('''pins 1 and 10''' on the DLP-USB1232H, pin 8 on the SPI chip, pin 1 on the voltage regulator) | ** All '''GND''' pins should be connected together ('''pins 1 and 10''' on the DLP-USB1232H, '''pin 8''' on the SPI chip, '''pin 1''' on the voltage regulator) | ||
You have to invoke flashrom with the following parameters: | You have to invoke flashrom with the following parameters: | ||
Revision as of 03:33, 5 September 2009
Recent versions of flashrom support the -p ft2232spi option which allows you to use a FTDI FT2232H/FT4232H based device as external SPI programmer.
This is made possible by using libftdi. flashrom autodetects the presence of libftdi headers and enables FT2232H/FT4232H support if they are available.
Devices
Documentation
DLP Design DLP-USB1232H
Setup
- You must connect pins 8 and 9, which configures the device to be powered by USB. Without this connection it will not be powered, and thus not be detected by your OS (e.g. it will not appear in the lsusb output).
- You need a 3.3V voltage regulator and two capacitors (e.g. 100nF and 10uF, but slightly different values should also work) to convert the 5V from USB to 3.3V, so you can power the 3.3V SPI BIOS chip.
- TODO: Details
- Connect the following pins from the DLP-USB1232H to the SPI BIOS chip:
- 18 (SK) to SCLK
- 16 (DO) to SI
- 2 (DI) to SO
- 5 (CS) to CS#
- The WP# and HOLD# pins should be tied to VCC.
- All GND pins should be connected together (pins 1 and 10 on the DLP-USB1232H, pin 8 on the SPI chip, pin 1 on the voltage regulator)
You have to invoke flashrom with the following parameters:
$ flashrom -p ft2232spi:ft2232_type=2232:port=A
