|
|
| (8 intermediate revisions by one other user not shown) |
| Line 1: |
Line 1: |
| * Using [[ISP]] requires some means to connect the external programmer to the flash chip.
| | {{#externalredirect: https://www.flashrom.org/user_docs/misc_notes.html }} |
| * Note that some external flasher(like the [[FT2232SPI_Programmer#Openmoko Openmoko debug board]]) do requires some soldering to connect it to the flash chip, while some other don't(The [[Bus_Pirate]] Has a pin connector on it).
| |
| | |
| == Connect to a clip ==
| |
| Some programmers, like the [[Bus_Pirate]] have pin connectors on them.
| |
| * '''Short''' Jumper Wires can be used to connect the programmer to the clip.
| |
| | |
| == Common issues ==
| |
| * Wires length, connection quality: Long wires, and bad connection can create some issues, so avoid them. If you can't and if you're flash chip is SPI, then lowering the SPI clock can make it work in some cases. Many programmers do support such option(Called spispeed with most of them, or divisor with ft2232_spi).
| |
| * When soldering wires, the wire tend to break near the soldering point, to avoid such issue, you have to prevent the wires from bending near the soldering point. To do that [https://en.wikipedia.org/wiki/Heat-shrink_tubing Heat-shrink_tubing] or similar methods can be used.
| |
Latest revision as of 13:13, 9 August 2024